During emulation a reset coming from
the target system is handled properly and a Target Reset & Go command is available to start an emulation with a target reset.
However, during break condition the
emulator ignores target resets. If a reset from the target
occurs during break condition, this may cause the emulator to get out
of synch with any devices on the target system that are affected by
reset and unexpected operation will result.
For this reason if you have a
hardware watchdog reset circuit in your target system you will need to
disconnect it while using the emulator. Note that this refers to a
hardware watchdog circuit in your target system and not to the watchdog
built into the microcontroller.
|
